2006-2011 Camry Aurion · Service Manual SUSPENSION & AXLE

INSPECTION

Inspection · Vehicles built from Jun 2006


INSPECT FRONT LOWER BALL JOINT

  1. ZX01712
    Inspect the turning of the ball joint.

    1. Secure the front lower ball joint assembly in a vise using aluminum plates.

    2. Install the nut to the front lower ball joint assembly stud.

    3. Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the 5th turn.

      Turning torque:
      1.0 to 3.4 N*m (10 to 35 kgf*cm, 9 to 30 in.*lbf)

      HINT:
      If the turning torque is not within the specified range, replace the front lower ball joint assembly with a new one.

  1. Inspect the dust cover.

    1. Check that the dust cover is not cracked and that there is no grease on it.

      HINT:
      If the value is not within the specified range, replace the front lower ball joint with a new one.

← REMOVAL (from Jun 2009)INSTALLATION (Jun 2006 – Sep 2006) →